点击图片查看大图
山东山矿机械有限公司可逆式锤式破碎机型号：PCFK1825 PCFK1818 PCFK1618 PCFK1616 PCFK1612 PCFK1608 PCFK1212 PCK1413
主要配件：双液复合锤头 高锰钢锤头 耐磨衬板 锤臂 销轴 反击板体 转子总成等。
型号：焦化系列
PCFK系列反击锤式破碎机
IMPACT HAMMER MILL
概述 BRIEF INTRODUCTION
PCFK系列反击锤式破碎机集锤破和反击破于一体，适用于中低硬度物料的细碎阶段，可将80mm以下的物料破碎到8mm以下。本系列机型具有破碎效率高、破碎产品粒度均匀、过粉碎比例低等优点。
As an integrator of hammer mill and impact mill, PCFK series of Impact Hammer Mill is used for secondary crushing of low- and medium-hardness materials. The size of material can be reduced from <80mm to <8mm. The mill enjoys advantages in high and constant capacity, excellent uniformity of final grain size, low fine grain content and etc.
应用范围FIELDS OF APPLICATION
PCFK系列反击锤式破碎机主要应用于火力发电厂循环流化床锅炉、焦化厂、钢铁厂等破碎煤炭，同时也可为矿山、化工等行业破碎矿石、石灰石、石膏、盐、焦炭等物料。
PCFK series of Impact Hammer Mill is mainly applied for crushing coal in power plants, coke ovens and iron & steel mill, as well as ore, limestone, gypsum, salt and coke.
工作原理MODE OF OPERATION
为获得理想的排料粒度和锤头的均匀磨损，采用振动给料机或专用入料槽在沿入料口全长上均匀给料。物料进入破碎机后，受到高速旋转的锤头冲击而破碎，并高速冲向破碎板再次被破碎，经过破碎板的反弹，再次被弹向锤头，物料在破碎腔内经过反复冲撞和互相碰撞而破碎，在反击板体下部排料口排出。产品粒度决定于转子的转速及转子与破碎板的间隙。
The uniform distribution of the feeding material at the entire width of the rotor via a vibrating feeder or a specially-designed inlet chute is requested for achieving an optimum final grain size as well as a uniform wear of the crushing parts. After entering the crushing cavity, the feed material is grasped by the rotating beater heads and then thrown against the grinding face at high speed to be crushed and again rebound to beater heads. The material is gradually crushed in a course of dash and inter-collision repeatedly and discharged out of the end of grinding face. Product size is determined by rotation speed of the rotor and gap between the rotor and the grinding wall.
PCK1825可逆破碎机锤头 山东山矿